Joggle definition sheet metal
Joggle (sheet Metal) A small offset near the edge of a piece of sheet metal. It allows one sheet of metal to overlap another sheet while maintaining a flush surface.How can the answer be improved? joggle definition sheet metal
A joggle is an offset formed to provide for an overlap of a sheet or angle which is projecting in the same plane. The inside joggle radii should be approximately the same as used for straight bending.
Joggle definition sheet metal free
The bend deduction is the amount the sheet metal will stretch when bent as measured from the outside edges of the bend. The bend radius refers to the inside radius. The formed bend radius is dependent upon the dies used, the material properties, and the material thickness.
In the following example, you will create a joggle defined on a surfacic flange, but this scenario is also valid for a joggle created on a web. Open the Joggle1. CATPart document. Click Joggle in the Aerospace Sheet Metal toolbar. The Joggle Definition dialog box is displayed.
Small Joggles formed in sheet metal work from 0. 7mm to 3mm thick and up to 140mm in width. Material Gauge Mild steel, Zintec, Galvanised Steel, Aluminium Alloys, Stainless Alloys, Brass and Copper.
An Aerospace Sheet Metal Feature is a set of Sheet Metal Features. This internal model complexity explains that it is possible that you need to call specific method to update internal Features links (i. e. : Joggle: ManageOnSupport method) and that we suggest to update the Part instead of the Aerospace Sheet Metal Feature.
Joggle presses can form multiple bends on sheet metal at the same time, in opposite directions when required and less than 90. Beckwood manufactures Triform Hot Joggles and Cold Joggles introducing heat to the process can help with tougher metals.
May 25, 2017 joggle (plural joggles) (engineering) A step formed in material by two adjacent reverse bends. (architecture) A notch or tooth in the joining surface of
OK, I've been doing sheet metal for more than 30 years, along comes Solidworks and it's just the best tool! I was born 30 years too early! Anyway when we do models or designs for flats to import into Fabriwin I always struggle with applying a bend allowance to the part.
Rating: 4.56 / Views: 350